This application is a test utility for reading and displaying states
of digital and analog inputs, and setting states of outputs. Read post of Tuesday18th June, 2013 for a full explanation.
This is a ClickOnce distribution so there is no fancy installer.
Eventually I may get around to using a proper installation utility which
will result in a single .exe or .msi setup file. For the moment I have
uploaded the installation files to Google Drive as a zip archive.
Download the zip file to your desktop and unzip it. This creates a
folder called ComduinoTerminal on your desktop (or a sub folder in the
folder where you extracted the zip file). Run setup.exe in this folder
to install the application. There is probably a better way of doing
this.... any suggestions would be welcome.
This new version has a panel on the form with a series of buttons, one for each output allowing the state of outputs to be set.
Download here: Comduino Terminal v2.0
This application is specifically for the Leonardo board. If you want to
use it with other boards, you need to modify the code, which basically
involves changing #defines for number of channels in the sketch and the
equivalent in the VB code. I have used the aliases which refer to pins
e.g. A0, A1 etc as described in ..Program
Files\Arduino\hardware\arduino\avr\variants so these may need to be
extended.
The accompanying sketch for a Leonardo board is here: Comduino1_0.ino
No comments:
Post a Comment